admin

回复 1# wolfdol

   In general, bad block skipping must use partition write mode. LINUX system uses multiple partitions for bad block management.  The size and location of the partitions are customized by the developer. So it must be set manually. Generally only suitable for new product development or mass production programming.

The bad block processing method is set in the config options.

For maintenance, The data is read from IC.  only hard copy can be performed generally.

admin

回复 3# wolfdol
   Unable to browse the picture or video
   I don't see anything, I can not understand what you said.

admin

回复 6# wolfdol
Can't visit the youtube in China

admin

回复 8# wolfdol
Do you read the T56/TL866II user guide about NAND?
All skip bad block function is complete.

set in config  <options>:
This is an example configuration actually used

下载 (142.75 KB)

2021-5-27 09:39

my Email:532007590@QQ.com

admin

回复 10# wolfdol

T56/TL866II is the same. this is new versions, Will be released these days.old version is only 8 partitions.But the method of use is the same

admin

so I am telling you that NAND flash memory write s ...
wolfdol 发表于 2021-5-27 09:45

???

admin

TL866II Plus does not have the same option as it, so I am telling you that NAND flash memory write s ...
wolfdol 发表于 2021-5-27 09:45

I can't understand, what is the problem you said?Isn't it a question of skipping bad blocks?
1. use skipping must program by partitions.
2. otherwise you only use a chip without bad blocks. or test more chips (if it is blank data on bad block, it can be programmed )

admin

回复 14# q519948746
最多钩选16个一般够用了吧？检查分区设置是否正确，是有的

admin

回复 17# q519948746

好的，当时觉得这个窗口太长。所以没有搞哪么多
新版本V11.00,最大到31个，
并且显示每个分区的开始地址，让设置更直观

下载 (131.72 KB)

2021-6-3 14:13

admin

回复 19# q519948746

这个TAB顺序，当时没有想到，有时间来改，切换根据控件的ID顺序来的，为了处理消息统一，ID的竖向排的，怕改乱了，暂时不改了。

多文件时，以后如果真的有人发现不够用，再来改，现在只是后面15个文件名不可见。
临时使用方案：
在单文件界面，勾选17-31， 后切换到多文件界面，后面分区的文件名及路径使用默认设置Part_xx.bin