admin

回复 1# krz1
T56 Programmer
you can DIY a adapter BGA149 to DIP48.
ZIF48 pins is assigned as ONFI standard(16 bits NAND):
All VCC and VCCQ connected together.
All Vss and VssQ connected together.

下载 (92.3 KB)

2021-4-18 08:55

then set NAND parameters by the chip's data sheet.Please refer to the T56 user guide  section 10.3

下载 (45.37 KB)

2021-4-18 08:57

admin

回复 5# krz1

TL866II not support 16 bits and multiple CE/RBn pins

admin

回复 7# krz1


  you unable to rearrange the pinout of the programmer. you only DIY a special adapter for your IC

admin

回复 10# krz1
what's the Pinout of your IC?
VCC/VCCQ to ZIF12 and ZIF37
VSS/VSSQ to ZIF13 and ZIF36

Connect all VCC/VCCQ on PCB  
Connect all VSS/VSSQ on PCB

set
disable Pin Detect.

admin

回复 13# krz1
Yes,
WP is a write protection Pins. must be connected.

admin

回复 15# krz1

ALL VSSF  to GND
all  VDDF  to VCC 1.8V

select a chip model with VCC=1.8V  ,  16bits  TSOP48

admin

回复 20# krz1

1.There must be an adapter.(or a PCB to test)

2. we can not be able to guarantee  the test,  because no the correct data sheet.

admin

回复 30# krz1

下载 (398.44 KB)

2022-2-8 16:10

admin

回复 33# krz1

Yes this is a bug ,we will fix it about saving config.

admin

回复 35# krz1

Read the first block is same with other blocks? just diffrent address.Unless the chip has other restrictions.

The reason can only be analyzed by finding the datasheet of the chip.

admin

回复 39# krz1


    saving the configuration  has been fixed in V11.90

admin

回复 42# krz1

no useful! no correct data sheet. I can do  nothing.