Program problem PC28F256P30BF (BGA64)

Unfortunately, I'm unable to program PC28F256P30BF (BGA64) with adapter XG-BGA64P2-1.0mm

Each time I have error buf_val 0xFF but ic_val 0x00 with different addresses.

管理员

Rank: 9 Rank: 9 Rank: 9

2^#

admin发表于 2023-7-21 17:01 | 只看该作者

回复 1# Test

I did not find any errors during my testing.

TOP

中级会员

Rank: 3 Rank: 3

3^#

Albano.Matos发表于 2023-7-21 19:07 | 只看该作者

回复 Test

I did not find any errors during my testing.
admin 发表于 2023-7-21 17:01

As a User,
Hopefully is only a bad contact or resistance, on adapter side or chip side. Try cleaning both , or chip first, then the socket , then the rest.
Be carefully all the time

Hope it helps

TOP

公共组

Rank: 1

4^#

Test发表于 2023-7-27 02:35 | 只看该作者

I bought a programmer from another manufacturer with an BGA64 adapter, PC28F256P30BF was erased and programmed normally.
I repeat the same procedure on the T56 and I have error.

TOP

公共组

Rank: 1

5^#

Test发表于 2023-7-27 03:47 | 只看该作者

Chip erased with T56 and blank verified on other programmer successfully.
Chip programmed and verified on other programmer.
Then I read chip on T56, after I pressing verify I got error on address A, I close verify window, open it again, press verify and got error on address B, ....... got error on address C.

TOP

公共组

Rank: 1

6^#

Test发表于 2023-8-2 05:44 | 只看该作者

Your error is similar to mine. Pay attention to the firmware erasing time

Admins did not answer anything for 2 months with a similar problem.

http://forums.xgecu.com/viewthread.php?tid=1059&extra=page%3D1

TOP