VGA_adpter DIY for T56 Programmer (VGA 适配器座)
PCB:
 VGA_adapter.rar (560.46 KB)
注意：HDMI部分线路不可以手工连线制作适配器，HDMI信号工作频率达900MB/s,
线路长短不同与线路交叉都无法使HDMI正常工作
VGA线： 最好使用15针全通线。
检查方法：PIN 4 9 10 11 12 15 必须有连通， 并且PIN4 9 11 12 15 不可以接地，
PCB板上的VGA头为母头
HDMI线：可以使用通用的HDMI线
Note: Not to make a adapter by manually connection。
HDMI signal working frequency up to 900mb / s,
The HDMI can not work normally because of the different length of lines and the crossing of lines
The VGA head on PCB board is female.
用于串打打印与在线编程的VGA转USB 及 USB转耳机线，可以使用淘宝的的转接线。也可以按下图自制。多种线都能通用，软件能自动识别。
For serial printing and ISP on-line programming.
You can use VGA to USB3.0/USB2.0 cable and VGA to headset cable Sold on WEB.
It can also be made according to the following figure.
All kinds of lines can be recognized automatically by the software.
|
