XGecu Programmer Forums - Powered by Discuz! Board

标题: adesto at45db321e write problem [打印本页]

作者: Dmitry 时间: 2022-11-3 04:50 标题: adesto at45db321e write problem

APP Version : 12.35 Model : TL866II Plus

   Device : AT45DB321E[Page528] @SOIC8

Note:

Must Connect a 100P Capacitor between Pin MISO and Gnd!!!

and  Connect a 2.2uf Capacitor between Pin VCC and Gnd!!!

All right, i go to the steps. Step by step.

APP Version : 12.35 Model : TL866II Plus

   Device : AT45DB321E[Page528] @SOIC8

Pins Detected Passed!

ID: 0x 1F 27 ......OK!

Erase  ...Succeeded. Time : 40.576 S

Programming FLASH ...Succeeded. Time : 52525ms

Verifying FLASH ...

ERROR! FLASH Address:0x001EF0 Buf_Val:0xE6 IC_Val:0x06

Programming  ...Failed

why does the programmer not write the chip? if I use another programmer other than xgecue, everything is written and there are no errors.
Help me!!!

作者: admin 时间: 2022-11-3 13:26

回复 1# Dmitry

TL866II Must Connect a 100P Capacitor between Pin MISO and Gnd!!!
and Connect a 2.2uf Capacitor between Pin VCC and Gnd!!!
If possible, please use T48 programmer, which is quite stable without adding capacitance.

作者: Dmitry 时间: 2022-11-13 17:28

Hi Admin, of course I connected these capacitors, 100pF between SI and ground, 2.2uF between Vcc and ground. Nothing changed.

作者: admin 时间: 2022-11-15 11:11

回复 3# Dmitry

MISO is SO . Not SI.

作者: Dmitry 时间: 2022-11-20 18:14

回复 Dmitry

MISO is SO . Not SI.
admin 发表于 2022-11-15 11:11

Forgive me for typing, of course, SO leg. Error has not changed

作者: Dmitry 时间: 2022-12-4 03:50

Hi, I bought T56 and there are no such problems with it, I also found a problem with the definition of pages, tl866 did not give the correct definition of pages

欢迎光临 XGecu Programmer Forums (http://forums.xgecu.com/)