XGecu Programmer Forums - Powered by Discuz! Board

标题: EMMC Boot config viewing in log [打印本页]

作者: STALKER_71 时间: 2021-3-20 07:56 标题: EMMC Boot config viewing in log

Hi. Can you add boot config of extcsd parameters to emmc analysis window. For example:Boot bus config [177]: 0x48 , Partition config [179]: 0x00.
H/W reset function [RST_N_FUNCTION]: 0x01

These are very important parameters and I would like to see them immediately in main log window after clicking on the "analysis ic" button. It's save many time in work with emmc and make it easy for users.

作者: admin 时间: 2021-3-22 09:23

回复 1# STALKER_71

OK

作者: STALKER_71 时间: 2021-5-4 00:03

Thanks for adding this small upgrade. Its save many time when work with emmc. Why you dont write about it in changelog? Detailed changelog show for users and potentional buyers how hard you work to make software better.

欢迎光临 XGecu Programmer Forums (http://forums.xgecu.com/)