标题: T48 Help [打印本页] 作者: EQtest 时间: 2024-5-28 14:32 标题: T48 Help
Hello
I tried programming M48T08-100 (ST) using T48.
The read was successful.
However, an error occurs when writing.
The content of the error is that the last address cannot be written.
I tested by setting all data to FF and leaving all addresses blank, but the last address does not become FF.
The T48 firmware I'm using is 1.31.
I am using software version 12.66.
What's wrong?
Please tell me.作者: Iamwally 时间: 2024-5-29 10:48
I am having a similar issue with T48 and trying to program Gal16V8D with PLCC20 adapter. It is like it cannot write the last bit to the card. Perhaps a bug in 12.66 and the T48?
