返回列表 发帖

Programmer not recognized after firmware update failed

Hello,
I just installed version 11 of the software for the TL866II Plus on a Windows 10 64 bit computer.  The first time I ran the program it told me to update the firmware, then it told me that it didn't have write access to the folder it was installed in.  I tried to provide the permissions, but the change I made did not resolve that issue.

I decided to upgrade the firmware anyway, and it started to run OK but then it stopped and told me that the upgrade failed and to remove the programmer.  (I'm sorry I don't recall the exact message.)

Now, when I plug in the programmer, the power light is solid and the run light is flashing.  When I start the program, it does not recognize the programmer, and the run light continues to flash.

Is there anything I can do to fix this, or is my programmer bricked?

Thanks

I tried it again today, and now it works.  I didn't do anything with it, it just works.  Go figure.

TOP

回复 1# rickseiden
run light is flashing:  USB driver software is damaged, reinstall the software

TOP

返回列表 回复 发帖